Alinco DR-635 Pre Amp Repair

I came across a DR-635 that was dead.  After removing the panels it was clear that the pre amp IC had failed.  Note that the heatsink comes out of the board thru a slot for cleanup.  Below are pictures of the repair.  I used solder paste and a hot air station to repair the unit after initial trace and PCB repair using superglue (Don’t breath fumes).  Parts were purchased from Alinco.


 

 

 

Share with others!
Share on Facebook
Facebook
Tweet about this on Twitter
Twitter
Email this to someone
email
Digg this
Digg

Leave a Reply