www.shaneburrell.com Telecom – Electronics – HAM Radio – Test Equipment – Rescue

26Jul/170

Kurt DX6 First Use, Work Setup How to, fixture plate

Kurt DX6 First Use, Work Setup How to, fixture plate

Using the Kurt DX6 for the first time. Work Setup How-To. Finishing the fixture plate run.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
Filed under: Machining No Comments
26Jul/170

KURT DX6 Vise Review

KURT DX6 6" Vise Review

I finally made a decision and purchased a Kurt DX6 6" Vise. Here is a review of the unboxing. These vises are top notch and I really wished I had ordered two.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
Filed under: Machining No Comments
19Jul/170

RZR Rollbar Super Mount Part 1 & 2

RZR Rollbar Super Mount Part 1 & 2

Prototyping a smaller CNC tooling plate. I had a few issues during machining this part and I go over how I corrected them.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
Filed under: Machining No Comments
18Jul/170

CNC Tooling Plate Recovery

CNC Tooling Plate Recovery

Prototyping a smaller CNC tooling plate. I had a few issues during machining this part and I go over how I corrected them.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
Filed under: Machining No Comments
13Jul/170

CNC Coolant Care and LED light upgrade in the VMC

CNC Coolant Care and LED light upgrade in the VMC

I go over how I maintain my coolant and show the results of upgrading to LED lighting in my VMC.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
Filed under: Machining No Comments
13Jul/170

CNC Mill Reverse Osmosis Install for Coolant Fill

CNC Mill Reverse Osmosis Install for Coolant Fill

I installed a Reverse Osmosis system to top off my vertical machining center coolant tank with almost pure water. I also did some other upgrades and did a quick overview of past upgrades.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
Filed under: Machining No Comments
13Jul/170

Fixing CNC Tap Trays. Patreon Page

Fixing CNC Tap Trays. Patreon Page

I had a bore size issue on the #1 Tap Adapter Trays. This is the setup of job to fix the bore size and chamfer. I made a math error on the first tray. I have a Patreon page if you would like to see more videos, access to design files (Electronics and Mechanic), and pre release access. Thanks for watching!!!! Please subscribe.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
2Jul/170

CNC Rigid Tap Adapter Holder Trays

CNC Rigid Tap Adapter Holder Trays

Making trays for Bliz style rigid tap adaptors.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
Filed under: Machining No Comments