www.shaneburrell.com BLOG Search – Rescue – Scuba – Diving – Telecom – Electronics – HAM Radio

6Jan/120

Alinco DR-635 Pre Amp Repair

I came across a DR-635 that was dead.  After removing the panels it was clear that the pre amp IC had failed.  Note that the heatsink comes out of the board thru a slot for cleanup.  Below are pictures of the repair.  I used solder paste and a hot air station to repair the unit after initial trace and PCB repair using superglue (Don't breath fumes).  Parts were purchased from Alinco.


 

 

 

Submit to StumbleUponhttp://www.shaneburrell.com/wp-content/uploads/2012/01/photo-2-1024x764.jpgDigg ThisSubmit to reddit
Comments (0) Trackbacks (0)

No comments yet.


Leave a comment

No trackbacks yet.