www.shaneburrell.com Telecom – Electronics – HAM Radio – Test Equipment – Rescue

29Aug/170

FANUC OM CRT to LCD Conversion

FANUC OM CRT to LCD Conversion

Adjustment of the Fanuc OM 9" CRT and complete replacement to a color LCD.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
23Aug/170

PCB CNC Enclosure – Finishing the bottom

PCB CNC Enclosure - Finishing the bottom

Finishing up the bottom section of the CNC PCB Enclosure.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
8Aug/170

PCB CNC Enclosure – Balax Thread Forming

PCB CNC Enclosure - Balax Thread Forming

Making a CNC'd PCB enclosure with form tapped holes for the solid state relay multiplexer.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
8Aug/170

Simple Step Jaw for PCB CNC Enclosure

Simple Step Jaw for PCB CNC Enclosure

Making a simple step jaw for a machining a pcb enclosure.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
Tagged as: , , No Comments
3Aug/170

Kaizen Foam CNC Toolbox

Kaizen Foam CNC Toolbox

Some downtime in the shop, fixing the facemill, and improving efficiency of the new Kobalt Toolbox with Kaizen Foam. This saves a lot of space and organizes tools in any toolbox especially machinist tools.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
Filed under: Machining No Comments
3Aug/170

Vise Knob and Destruction of a Face Mill & Crash

Vise Knob and Destruction of a Face Mill/Crash

Making a knob for the Kurt DX6 vise. Crashing a facemill.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
Tagged as: , , , No Comments
3Aug/170

Cummins Fuel Filter Nut Tool Fixture

Cummins Fuel Filter Nut Tool Fixture

Making a soft jaw fixture using Phasic Tooling Components blanks for the Kurt vise. This holds 3" round stock in the vise while machining the Dodge Cummins Fuel Filter Nut Tool for CNC Machining. Check out my patreon page via my page banner, become a support and get design files and early access to videos.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
26Jul/170

Kurt DX6 First Use, Work Setup How to, fixture plate

Kurt DX6 First Use, Work Setup How to, fixture plate

Using the Kurt DX6 for the first time. Work Setup How-To. Finishing the fixture plate run.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
Filed under: Machining No Comments
26Jul/170

KURT DX6 Vise Review

KURT DX6 6" Vise Review

I finally made a decision and purchased a Kurt DX6 6" Vise. Here is a review of the unboxing. These vises are top notch and I really wished I had ordered two.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
Filed under: Machining No Comments
19Jul/170

RZR Rollbar Super Mount Part 1 & 2

RZR Rollbar Super Mount Part 1 & 2

Prototyping a smaller CNC tooling plate. I had a few issues during machining this part and I go over how I corrected them.

Share with others!
Share on FacebookTweet about this on TwitterEmail this to someoneDigg this
Filed under: Machining No Comments