Below you will find pages that utilize the taxonomy term “diy”
RZR 1000 Front Diff noise issues and troubleshooting.
I tear into my RZR S 1000 to determine a new noise coming from the front diff. Links to the items used in this video. Bearing Kit with Seals https://amzn.to/2HRSQwe Plastic Anchor Remover and Spares https://amzn.to/2HS1rix Snap Ring Pliers https://amzn.to/2FF5zig Roll Pin Air Hammer Bit https://amzn.to/2HOrdEp (Requires Machining!)
The best trailer money can buy. My two year review.
A two year long term review of the the Big Tex 14OD Dump Trailer. This is one of the best trailers on the market and is extremely useful in most transport tasks. Perfect for the homeowner or professional landscaper.
Getting Started on an older Fanuc OM CNC Mill.
How I start my Fanuc OM based CNC Mill. How to get started or use an older Fanuc OM based mill. I purchased a used CNC mill and have been using it successfully for over a year. For DIY type operation, it’s been reliable and capable. Excel VMC mills, in particular, seem to be very reliable, easy to work on and I’ve been able to source parts. I use Fusion 360 along with custom post-processing to my DNC to make parts. The oil absorbers I use are at: https://amzn.to/2CGWHbu
RZR Factor 55 Prolink XTV Install on a RZR S 1000
Installation of the Factor 55 Prolink XTV winch shackle on my RZR S 1000. Soft Shackle - https://amzn.to/2q0vwSl Prolink UTV XTV - https://amzn.to/2Gw4hW6
Kurt Vise Step Jaw CNC operation for PCB CNC Enclosure
Making a simple vise step jaw for a machining a 6061 PCB enclosure for a solid state relay module / controller. The design was done in Fusion 360 and machined using my Excel VMC. The step jaw fits the DX6 Crossover Kurt vise.
ER16 Collet Storage. The crash...
Making an ER 16 Collet Storage Tray. I crashed a tool and a part!!!!!
Haimer Repair, Doom and Vise Jaws Part 2
Vise Jaws Setup and machining. Part 2 of making some vice jaws.